Umbrella Repair-Roman Umbrella General Troubleshooting

1. Where the handle of the Roman umbrella is prone to failure, the inner parts of the new Roman umbrella handle are cast aluminum and the rotating bearing assembly bears a pressure of 100kg. If the wind is too strong to close the umbrella, it is easy to be pulled up by excessive force, causing some parts of the component to crack at the force point, which is slowly affected by the humidity in rainy days. It will lead to long spot oxidation, and if it is serious, it will break directly, which will reduce the service life and affect the opening and failure of the umbrella. Replacement parts only: Currently only components are available for replacement

2. Umbrellas placed at the tuyere are subject to wind all the year round. Large umbrellas (smaller ones are better) have large sunshade area and large wind resistance. It is easy to cause uneven umbrella surface after using for a period of time. If the middle B plate is cracked, you can retract the umbrella handle fixing screw in time, and fix the center line fixing device. The appearance of the umbrella is normal, (if the B umbrella plate C plate is cracked), it needs to be replaced.

3. For the failures that do not usually occur, the pull rope is generally invisible from the outside, and it is very important in the product umbrella. The brand umbrella uses fire protection rope, which is waterproof, wear-resistant, anti-oxidation, and has a load-bearing capacity of 200kg. Typical cases, some umbrellas During use, the umbrella was hung by the strong wind, and the appearance of the umbrella did not find any faults. I did not check carefully. The power-assisted rotating shaft in the umbrella fell off, and when the handle was turned, it directly rubbed on the umbrella frame, and it broke after a long time.